Carlton 2518 Instrukcja Operatora Pobierz pdf (Strona 118)

18” DRUM SERVICE

FEED WHEEL MOTOR

• When the motor assembly is off the

machine, move it to a workbench for

easier access. Then, remove the 1” nut

that is inside the coupling. You may

need to use a vise to hold the motor

steady while you break the nut loose

since it was put on with LocTite® 262

and then tightened to 150 ft. lbs.

CAUTION: Always wear eye

protection when working on hydraulic

components.

• There is a special tool required to

separate the motor and coupling once

it is off the machine, contact J. P.

Carlton or your local dealer to

purchase the puller.

• Attach the separating tool to the coupler

as shown and screw the three bolts from

the bushing into the tool in the outside

holes. Screw the bolts into the coupling

as far as they will go. Now turn the bolt

in the center of the tool to pull the

coupling off the feed wheel motor.

• Remove the torque arm held on with two

1/2” bolts. (The torque arm looks

slightly different on the upper feed

motor, but is still held on with two

bolts.)

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 198 199

Brak uwag

Carlton 2518 Instrukcja Operatora Strona 118