Carlton 2518 Instrukcja Operatora Pobierz pdf (Strona 103)

18” DRUM SERVICE

CUTTER SYSTEM

• After the clearance has been set, tighten

the anvil bolts (1/2”-13) and torque to

75 ft. lbs.

• Retighten the nuts on the adjustment

bolts that were loosened earlier.

• Recheck the anvil/knife clearance to

make sure nothing changed when

tightening the bolts.

• Clearance should be .070” and .090”

(1.78 – 2.29 mm).

• ALWAYS REMEMBER TO CLOSE

THE CUTTER DRUM DOOR

AFTER SERVICING CUTTER

DRUM.

• INSTALL THE DOOR LOCK PIN

AND PADLOCK.

• Check condition of cutter drum door.

Make sure the hinges are not damaged

and that the door closes completely with

no gaps or openings; check both sides.

If there are any problems go to Servicing

Cutter Drum Door later in this section.

NO GAPS OR OPENINGS AROUND DOOR

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 198 199

Brak uwag

Carlton 2518 Instrukcja Operatora Strona 103